Click here to go to UPSCALE home page.
Click here to go to I Year Lab home page.

You can jump directly to a section of this specification sheet by selecting an item below and clicking the left button.


Gunn Power Supply


[image]

Manufacturer: Philips
Model: PM 7815


Description


Contains manually adjustable DC voltage source with the range 0-20 V.




Specifications


Power110, 127, 220 or 240 VAC/40 VA, 50-60 Hz
Voltage0..--15 VDC (factory preset max of --10 V)
Stability<0.05% or <3 mV at 10% mains fluctuations
Internal resistance (dynamic)
1000 Hz : 20 M Ohms10000 Hz : 60 M Ohms
10000 Hz : 200 M Ohms250000 Hz : 200 M Ohms
Rise time<= 50 µs
Ripple voltage<= 1 mV rms
Modulation circuit
Frequency1000 Hz square wave
Stability±5 x 10 e-4 / °C
Square wave ampl.Maximum --3.3 V unloaded. >= --2.0 V at load 50 mA
Square wave currentMax. 60 mA



Click here to go to the top of this page.


Operating Instructions


  1. Adjust voltage on back side as required (normally 220 V).
  2. Make sure the voltage control knob is fully counter-clockwise.
  3. Switch on the power supply.
  4. Connect Gunn-oscillator and/or PM 7026X (diode modulator). For use without modulation, set modulation switch off.
  5. Voltage and current reading-mode is toggled by switching the V/I switch (V for voltage).



Click here to go to the top of this page.


keywords: voltage source, electrical source, current source.


Document created July 18, 1996. Original author: Jaime Espinoza.
Last updated 08/01/96. Revised by Jaime Espinoza and David Harrison.