Click here to go to UPSCALE home page.
Click here to go to I Year Lab home page.

You can jump directly to a section of this specification sheet by selecting an item below and clicking the left button.

X-Y Recorder

Manufacturer: Riken Denshi
Model: F-3F

Description

Small, lightweight plotter with X-Y recording capabilities.

Specifications

Input sensitivity	12 ranges between 0.1 mV/cm and 20 V/cm.
Input Impedence	10 M Ohms fixed on all ranges.
Accuracy	Within ±0.2 %
Power requirement	AC V 50/60 Hz, 17 W

Click here to go to the top of this page.

Operating Instructions

Set the ZERO-MEAS switch to ZERO.
Set the pen lift switch UP and turn POWER switch ON.
Connect the Input circuit to the input terminals (grounding assures stable recording).
Adjust Gain and Damping of the Amplifier as requirfed.
Adjust response speed of X and Y plotting (Apply same voltage at the same time to X and Y, then gradually increase/decrease the voltage until desired response speed is obtained).

Caution!

For accurate measurements:

Do not operate recorder for long periods of time with high oscillation or gain.
Avoid humidity and dust (cover recorder when not in use).

Click here to go to the top of this page.

keywords: pen recorder, frequency measurement device, time measurement device, electrical measurement device, voltage measurement device, voltmeter.

Document created July 17, 1996. Original author: Jaime Espinoza.
Last updated 07/26/96. Revised by David Harrison.